Posted on January 6, 2010March 11, 2024 by Dale Phillips Review: Checklist of Technical Drawings of Musical Instruments in Public Collections of the World by Rob van Acht Review: Checklist of Technical Drawings of Musical Instruments in Public Collections of the World by Rob van Acht Reviewed by Robert Lundberg Originally published in American Lutherie #43, 1995 Checklist of Technical Drawings of Musical Instruments in Public Collections of the World Rob van Acht Celle, Germany: Moeck Verlag and Gravenhage The Netherlands: Haags Gemeentemuseum 1992. 185 pp.; 7 color plates, paper covers Hfl. 49.00 (approximately $30.00) This checklist of technical drawings is authored by R.J.M. (Rob) van Acht, Curator of Musical Instruments at the Haags Gemeentemuseum (Postbus 72, 2501 CB The Hague, The Netherlands). It is a listing of somewhat over 450 drawings of musical instruments which are available for purchase from selected museums or collections. The checklist is a production of the Documentation Centre [sic] for Musical Instruments at the Gemeentemuseum where a complete collection of the drawings listed is maintained. Mr. van Acht and his staff at the Gemeentemuseum deserve our thanks for assembling the collection and compiling this checklist as does Moeck Verlag for cosponsoring its publication. The term technical drawing as used by this author and museums in general should perhaps be explained. These are full-size (1:1 scale) mechanical (outline) drawings that basically show what the instrument looks like from the outside. In the case of stringed instruments this external appearance is shown in several views with greater or lessor details of construction. They are usually prepared by the museum staff who have varying degrees of specific knowledge of the instrument’s construction. Although instrument makers will find most of the drawings to be of some value, the primary use as seen by the museums is organological. That is, the drawings are intended to be used by scholars (organologists) in their studying and writing about the classification, history, technology, and uses of musical instruments. And despite much discussion, complaints, and appeals, the museum community persists in their mistaken belief that some critical structural details and measurements are unessential information. These would include, for example, specific wood types, body cross sections, archings, and thickness measurements. So don’t be disappointed if a drawing you might send for has a serious lack of details, especially interior construction such as barring sizes and locations, and soundboard and back thickness measurements. Become A Member to Continue Reading This Article This article is part of our premium web content offered to Guild members. To view this and other web articles, join the Guild of American Luthiers. Members also receive 4 annual issues of American Lutherie and get discounts on products. For details, visit the membership page. If you are already a member, login for access or contact us to setup your account.
Posted on January 6, 2010March 11, 2024 by Dale Phillips Review: Making Stringed Instruments — A Workshop Guide by George Buchanan Review: Making Stringed Instruments — A Workshop Guide by George Buchanan Reviewed by C.F. Casey Originally published in American Lutherie #26, 1991 and Big Red Book of American Lutherie Volume Three, 2004 Making Stringed Instruments — A Workshop Guide George Buchanan Sterling Publishing Co., 205 pp. ISBN 0-8069-7464-8 You don’t have to look at the publishing information to know this is a British book. You don’t even have to depend on the usual vocabulary clues. In fact, they’re not even all here. The book uses “clamps” rather than the dead-giveaway “cramps,” although it does refer to “timber” rather than “lumber.” It’s the style, that unmistakable tone typical of English do-it-yourself books: not exactly formal, not exactly old-fashioned (in fact, the book was first published in 1989), but just subtly different in flavor from its North American counterparts. It’s more than just diction and syntax that make this book different, it’s the approach to the material. As the title suggests, the book is about a variety of instruments: violin, viola, and cello; mandolin and mandola; and classical and archtop guitars. However, rather than treating each instrument more or less independently, as most books of this type seem to do, Buchanan spends fully half the book dealing with the violin and viola, and then adds comparatively short chapters covering those aspects of the other instruments which are different from the violin. He does spend somewhat more time on the mandolin and mandola, as the first flat-top-and-back instruments in the book. Become A Member to Continue Reading This Article This article is part of our premium web content offered to Guild members. To view this and other web articles, join the Guild of American Luthiers. Members also receive 4 annual issues of American Lutherie and get discounts on products. For details, visit the membership page. If you are already a member, login for access or contact us to setup your account.
Posted on January 6, 2010March 11, 2024 by Dale Phillips Review: 1/1: Quarterly Journal of the Just Intonation Network Review: 1/1: Quarterly Journal of the Just Intonation Network Reviewed by Edward L. Kottick Originally published in American Lutherie #3, 1985 and Big Red Book of American Lutherie Volume One, 2000 1/1: Quarterly Journal of the Just Intonation Network Vol. 1, No. 1, Winter 1985 School of Music, The University of Iowa 1/1 is a new journal that is attempting to supply a support system for composers, performers, and instrument builders who are exploring the resources of Just Intonation. It is well written and nicely produced, and considering the subject matter, remarkably free of jargon. Just Intonation (the two words are always capitalized) is precisely defined by Editor-in-Chief David B. Doty, in his editorial, as “any system of tuning in which all of the intervals may be represented by ratios of whole numbers, with a strongly implied preference for simple ratios” (hence the 1/1 title of the journal). So far so good — simple ratios produce pure, i.e., beatless, intervals; but in the next sentence Doty declares that in a musical context such intervals are always recognized as consonant. Although he states that “this fact has been known since the third millennium B.C.,” he does not explain that he is referring to consonance in the physical sense, rather than in the musically-meaningful, perceptual or harmonic sense. In the first, consonance is defined in terms of the purity of the interval; but in the second, consonance is defined in terms of its relationship with dissonance. A tonic chord is a consonance, no matter how it is tuned, or even if it is out of tune. On the other hand, a dominant 7th chord is a dissonance, even if all its intervals are pure. Become A Member to Continue Reading This Article This article is part of our premium web content offered to Guild members. To view this and other web articles, join the Guild of American Luthiers. Members also receive 4 annual issues of American Lutherie and get discounts on products. For details, visit the membership page. If you are already a member, login for access or contact us to setup your account.
Posted on January 6, 2010March 11, 2024 by Dale Phillips Review: From the pages of Experimental Musical Instruments, Volume 1 Review: From the pages of Experimental Musical Instruments, Volume I Reviewed by Tim Olsen Originally published in American Lutherie #9, 1987 and Big Red Book of American Lutherie Volume One, 2000 From the pages of Experimental Musical Instruments, Volume I Experimental Musical Instruments Out of print Ever wonder what it would sound like if the wind blew through 19' stainless-steel bands attached to your roof? If so, you are the kind of person to relish this intriguing and enlightening little effort from the different drummers over at Experimental Musical Instruments magazine. The wind instruments on the compilation provide the most “musical” (accessible) selections while the percussion instruments provide the sort of material that goes well on art-film soundtracks. Of particular value to luthiers are the four tracks which feature strange and wonderful string instruments. The Puget Sound Wind Harp is hybrid of an aeolian harp and a small house. The wind plays upon the 3/8" steel ribbons to make sounds of a predictably low frequency. The tape gives a hint of what must be a sort of tooth-rattling “om.” Become A Member to Continue Reading This Article This article is part of our premium web content offered to Guild members. To view this and other web articles, join the Guild of American Luthiers. Members also receive 4 annual issues of American Lutherie and get discounts on products. For details, visit the membership page. If you are already a member, login for access or contact us to setup your account.
Posted on January 6, 2010March 11, 2024 by Dale Phillips Review: The Fender Guitar by Ken Archard Review: The Fender Guitar by Ken Archard Reviewed by Kevin Kobie Originally published in American Lutherie #27, 1991 and Big Red Book of American Lutherie Volume Three, 2004 The Fender Guitar Ken Archard The Bold Strummer, 1990 (reissue) ISBN 0-933224-48-6 This book was first published in 1977 by Musical News Services Ltd. London and at the time was the only book available on vintage Fender guitars. It contains the personal history of Clarence Leo Fender, the companies he started, and some of the key people he worked hand-in-hand with. There is a good general-features chapter with serial number information. The number sequences give two- to four-year spans listing the beginning of each consecutive hundred-thousand series. Become A Member to Continue Reading This Article This article is part of our premium web content offered to Guild members. To view this and other web articles, join the Guild of American Luthiers. Members also receive 4 annual issues of American Lutherie and get discounts on products. For details, visit the membership page. If you are already a member, login for access or contact us to setup your account.
