Posted on June 24, 2019May 1, 2020 by Dale Phillips Grading and Resawing Lutherie Wood Resawing Lutherie Wood by Bruce Creps previously published in American Lutherie #91, 2007 See also, “Sharpening the Stellite Teeth on the 3" Hitachi Blade” by Bruce Creps “Grading and Curing Lumber” by Bruce Creps Harvesting, milling, and processing tonewood can be a wasteful business. Much of the wood used by luthiers comes from large, older trees, elders worthy of respect. As someone fortunate enough to work with these rare, high-grade woods, one of my top goals is to minimize waste by processing this valuable resource efficiently. This article concerns the Hitachi CB75F resaw, though much of what follows is general enough to be applicable to other resaws. Luthiers who buy resawn sets might glean information about how their wood is processed and what to request or avoid when ordering. A note on nomenclature: A resaw is an upright or horizontal bandsaw set up to make uniform rip cuts. The front of the saw is where you start feeding a cut. The face of a board is its wide, longitudinal surface; the edge is its narrow longitudinal surface; the end is its crosscut surface. The resaw blade is made up of its band and its teeth (terms not necessarily interchangeable). I refer to vertical-grain wood in place of quartersawn wood to avoid confusion, since a sawyer can get vertical-grain cuts without quartering a log. Become A Member to Continue Reading This Article This article is part of our premium web content offered to Guild members. To view this and other web articles, join the Guild of American Luthiers. Members also receive 4 annual issues of American Lutherie and get discounts on products. For details, visit the membership page. If you are already a member, login for access or contact us to setup your account.