Posted on April 12, 2021April 14, 2021 by Dale Phillips Making Lining Strips — One Making Lining Strips — One by Rolfe Gerhardt Originally published as Guild of American Luthiers Data Sheet #71, 1978 and in Lutherie Woods and Steel String Guitars, 1997 I used to make lining strips one at a time, a long, tedious process. Then I visited Charlie Hoffmann in Minneapolis and was inspired to work out this gang-saw setup. The saws are 6" plywood saws, very small kerf, and are spaced on the radial arm shaft with 1/4" spacers. Three blades fit comfortably on my radial arm saw. The holder is a board with a guide strip and two hold-down springs. This holder is clamped to the radial arm saw table. I hold the strip I am sawing with my other hand. Become A Member to Continue Reading This Article This article is part of our premium web content offered to Guild members. To view this and other web articles, join the Guild of American Luthiers. Members also receive 4 annual issues of American Lutherie and get discounts on products. For details, visit the membership page. If you are already a member, login for access or contact us to setup your account.