Posted on October 19, 2026October 30, 2026 by Dale Phillips Get Bent! A Versatile Shopmade Side Bender Get Bent! A Versatile Shopmade Side Bender by Mike Doolin Originally published in American Lutherie #74, 2003 and Big Red Book of American Lutherie Volume Seven, 2015 Here’s a side bender that fully supports the waist during the bend. It uses spring tension to keep the steel sheets in contact with the side at all times. The lower sheet is .007˝ spring steel, while the upper sheet is thin perforated stainless. They’re both permanently attached to the butt end of the form. At the other end, the lower sheet is attached to a pivoting frame with three springs; the upper sheet has its own three springs attached to a wood block which hooks onto the same frame. This allows the sheets to be separated to insert the side into the bender; then the spring sets are hooked together so the frame can pull both into tension. Become A Member to Continue Reading This Article This article is part of the Articles Online featured on our website for Guild members. To view this and other web articles, join the Guild of American Luthiers. For details, visit the membership page. MEMBERS: login for access or contact us to setup your account.