Slotting Fretboards

by John Calkin

Originally published in American Lutherie #70, 2002 and Big Red Book of American Lutherie, Volume Six, 2013



Many luthiers skip the tedious chore of slotting their own fretboards, and with good reason. Preslotted boards are readily available in most of the common scale lengths, and I’ve never used a prepared board that wasn’t accurately made. However, if you wish to escape the use of ebony or rosewood, or if a strange scale length is calling your name, you may have no choice but to slot your own fretboards.

Accuracy and neatness are the attributes of a properly slotted board. Completing the job efficiently while keeping your temper under control requires a few basic tools. Be warned, however, that the frustration factor is harder to control than the necessary accuracy. Fretboard wood is usually the hardest and most abrasion resistant that can be found, and it doesn’t give in to slotting politely. It’s possible to buy your way out of this situation. It’s ironic that the cost of machine slotting is hardly more than a dedicated miter box, and can be a lot cheaper than a deluxe miter box. Assuming, that is, that you haven’t invested in a table saw just to cut fret slots.